Finished testing LCD and temperature successfully.

firmware/1.0/v01.ino

@@ -1,47 +1,24 @@
 /*
-  LiquidCrystal Library - Hello World
 
- Demonstrates the use a 16x2 LCD display.  The LiquidCrystal
- library works with all LCD displays that are compatible with the
- Hitachi HD44780 driver. There are many of them out there, and you
- can usually tell them by the 16-pin interface.
 
- This sketch prints "Hello World!" to the LCD
- and shows the time.
-
-  The circuit:
- * LCD RS pin to digital pin 12
- * LCD Enable pin to digital pin 11
- * LCD D4 pin to digital pin 5
- * LCD D5 pin to digital pin 4
- * LCD D6 pin to digital pin 3
- * LCD D7 pin to digital pin 2
- * LCD R/W pin to ground
- * LCD VSS pin to ground
- * LCD VCC pin to 5V
- * 10K resistor:
- * ends to +5V and ground
- * wiper to LCD VO pin (pin 3)
-
- Library originally added 18 Apr 2008
- by David A. Mellis
- library modified 5 Jul 2009
- by Limor Fried (http://www.ladyada.net)
- example added 9 Jul 2009
- by Tom Igoe
- modified 22 Nov 2010
- by Tom Igoe
- modified 7 Nov 2016
- by Arturo Guadalupi
-
- This example code is in the public domain.
-
- http://www.arduino.cc/en/Tutorial/LiquidCrystalHelloWorld
 
 */
 
 // include the library code:
 #include <LiquidCrystal.h>
+#include <OneWire.h>
+#include <DallasTemperature.h>
+
+// Data wire is conntec to the Arduino digital pin 4
+#define ONE_WIRE_BUS 11
+
+// Setup a oneWire instance to communicate with any OneWire devices
+OneWire oneWire(ONE_WIRE_BUS);
+
+// Pass our oneWire reference to Dallas Temperature sensor 
+DallasTemperature sensors(&oneWire);
+
+
 
 // initialize the library by associating any needed LCD interface pin
 // with the arduino pin number it is connected to
@@ -53,13 +30,17 @@ void setup() {
   lcd.begin(16, 2);
   // Print a message to the LCD.
 lcd.setCursor(0, 0);
-  lcd.print(" Hello, world!");
+  lcd.print(" @ElectroPepper"); 
+sensors.begin();
 }
 
 void loop() {
-  // set the cursor to column 0, line 1
-  // (note: line 1 is the second row, since counting begins with 0):
+
+// Call sensors.requestTemperatures() to issue a global temperature and Requests to all devices on the bus
+  sensors.requestTemperatures();
+
+
   lcd.setCursor(0, 1);
-  // print the number of seconds since reset:
-  lcd.print("Bout now !!!");
+  lcd.print(sensors.getTempCByIndex(0));
+lcd.print("C");
 }